Table of Contents
Advertisement
Operating Your Camera
V-REV: You can make vertical reverse to the scene. Move the arrow indicator to 'V-
REV' using UP or DOWN button. Set 'V-REV' mode to ON using LEFT or
RIGHT button. and press SET button.
IMAGE ADJ: This includes the factors related to the image quality or special function.
•TONE : As you increase the value using left or right button the whole level would
be brighter.
•SHARPNESS : As the value goes high, edge of image become strong and obvious. But
if increasing the value too much, some noise may appears on image
and image may looks unnatural.
•COLOR : As you increase or decrease the value, image chroma level increases or
decreases but the burst level doesn't.
COMMUNICATION: You can set the desired communication. Detail protocol refer to
page 48. Move the arrow indicator to 'COMMUNICATION' using
UP or DOWN button.
42
COLOR CCD CAMERA
User's Manual
•CAM ID NO. : You can set the desired camera id (0~255). NO 0 is used to the
Remote controller.
•CAM ID DISP : You can display the camera id on left-top of the screen.
•BAUD RATE : You can choose the baud rate to 9600/19200/38400bps.
•UART MODE : You can select parity bit to NON/EVEN/ODD. Data bit is set to 8bit and
stop bit is set 1bit. If you use the remote controller, you set 'UART
MODE' to '8-E-1'.
•RETURN PACKET : You can transfer a packet.
END: To move MAIN setup menu
RESET
To reset your camera to factory default condition.
EXIT
To finish setup menu.
COLOR CCD CAMERA
43
User's Manual
Advertisement
Table of Contents
