Advertisement
Figure 5
Connecting the FCM2041-U3 to the CC-5
OPERATION
Siemens Industry, Inc.
Building Technologies Division
Make sure that all cables snap fully into their connectors and close the locking levers
over the top of each cable connector. Secure the cable in the back box using cable
ties and the tie down points in the enclosure. The cable must have sufficient slack to
allow the inner door to open fully without putting stress on the cable.
In the normal standby condition the FCM2041-U3 displays the site specific custom
message, the time and date, and a synopsis of the system status.
When an event occurs in the system, the display enters the Alert mode. The event is
displayed, the local audible sounds and the tab on the display for the corresponding
event queue flashes. If the event type is Alarm, Trouble, or Supervisory, the appropriate
LED blinks. If the event caused notification appliances to sound the Audibles On
indicator lights. At the bottom of the screen an acknowledge button is displayed.
Pressing this button acknowledges the event and silences the local audible. Once all
events are acknowledged a reset button becomes available in the lower right side of
the display. If notification appliances were active, two additional buttons appear at the
bottom of the screen. These allow the operator to silence or unsilence the notification
appliances. When the notification appliances are silenced the Audibles Silenced LED
lights. The system can only be reset with the notification appliances silenced.
If more events are present in the system than can be displayed on a single screen a
scroll bar appears to the right of the event list. Pressing the up and down navigation
buttons to the right of the LCD allows the operator to move through the list. The
selected event is highlighted in the display. Pressing the More Info button will display
a screen showing details relating to the selected event. Other buttons also appear at
the bottom of this screen. There is an expanded text message available and a
selection to show all of the devices associated with the event that are active. The
operator can return to the previous screen by pressing the ESC button. (For more
detail on FCM2041-U3 operation, refer to the Cerberus PRO Modular Manual,
Document ID A6V11231627 .)
If the LED under one of the
button moves the highlight to the next queue. Use the
the first or last queue.
Figure 6
Connecting the FCM2041-U3 to the RNI
buttons above the LCD is lit, pressing the
4
buttons to shift to
A6V11231630_en--_b
Advertisement
