LG RCAW Operation & Maintenance Manual page 9

Be careful of disposal.
• When disposing the device, request to the spe-
cialized expert.
Be careful of high temperature.
• Because the machine part can be hot, do not
touch it with any part of your body.
• It can cause burns.
Be careful of device installation.
• Be careful of the clearance of the device during
the installation and make sure there are no sur-
rounding obstacles for the air cooling type and
that it is well ventilated.
Check.
• Execute the periodic check. If an issue is found,
stop operating the unit and contact the service
center.
• Insufficient check can cause fire, explosion and defect.
Be careful of air cooling type heat exchanger.
• Because the condenser of the air cooling type
device is sharp, do not touch the condenser.
• Protective net must always be kept installed.
• It can cause an injury.
Do not use jumpers or other tools to short out
components, or to bypass or otherwise depart
from recommended procedures.
• Any short-to-ground of the control board or
accompanying wiring may destroy the electronic
modules or electrical components.
Be careful of high voltage.
• Install separate wiring for the power and always install
and use dedicated power supply and circuit breaker.
• It can cause electric shock or fire.
Be careful of restarting.
• When the safety device of the product operates,
resolve the cause before re-operating.
• If you repeat this arbitrarily, it can cause fire and defect.
Be careful of sound or odor.
• If you hear a weird sound or smell weird odor,
immediately stop operating the unit and contact
the service center.
• It can cause fire, explosion and injury.
Use appropriate tools.
• Use appropriate tools used for the repair and
make sure to calibrate the measuring devices
precisely before use.
• If you use inappropriate tools etc, it can cause an accident.
It can cause an injury.
• Check the safety label of the safety device.
• Follow upper precautions and labels. If not, it can
cause injury or damage such as a fire etc.
• To prevent the generation of condensed water,
the connecting pipe to the evaporator, as well as
the evaporator itself, must be insulated.
Do not attempt to bypass or alter any of the
factory wiring.
• Any compressor operation in the reverse direction
will result in a compressor failure that will require
compressor replacement.
Operation & Maintenance Manual 9
Safety Considerations