Ysoft SafeQ Ethernet Reader Administrator's Manual page 9

There is a default network configuration used for Ethernet Reader:

DHCP=0

IP=192.168.0.100

NETMASK=255.255.255.0

GATEWAY=192.168.0.254

DNS=192.168.0.254

SERVERIP=192.168.0.254:5011

SERVERUPD=192.168.0.254:4096
The SERVERIP corresponds to the IP address and port of the YSoft SafeQ® Device Server. The IP and port are
used for card authentication.
The SERVERUDP corresponds to the SafeQ server and serves for firmware updates.
Emergency button is the way how to reset the terminal into default settings if anything goes wrong with the
configuration. Also it is possible to do some other actions such as force firmware update.
The correct procedure of using the emergency button is the following:

Unplug the reader power cable

Use a paper clip or a tiny screwdriver to push the emergency button. Hold the button pressed.

Plug the terminal power back.

The terminal now starts with short series of beeps with a longer pause between them. The action is se-
lected by releasing the button in the pause. Once the beep count reaches selectable maximum it starts
over again from 1. To cancel any selection unplug the power cable and release the button.

1 beep - do a set default configuration

2 beeps - do the firmware emergency update

3 beeps - do the normal firmware update

4 beeps - do the emergency reload - reset configuration to default and start emergency update
YSOFT SAFEQ® ETHERNET READER – ADMINISTRATORS GUIDE V1.3 [EN]
Picture 5 - Ethernet Reader configuration
6.12.2010
9/17