Advertisement
Quick Links
Parts
MCW40™ assembly
2-56 S/S socket screw
Nylon screw spacer
Nylon washer
Spring
This product is intended for expert users only. Please consult with a qualified technician for installation. Improper installation may result in
damage to your components. Swiftech assumes no liability whatsoever, expressed or implied, for the use of these products, nor their
installation. The following instructions are subject to change without notice. Please visit our web site at
4 pin conn.
to power
supply
Block
Gasket
Page 1 of 3
MCW40-T: Jun 1, 2002
Swiftech Inc., 1703 E. 28
MCW40-T
Back gasket
th
St., Signal Hill, CA 90806 T. (562) 595-8009 F. (562) 595-8769
Parts list
QTY
PARTS
1
3/8" vinyl tubing
4
Tube insert
4
Thermal compound
4
Socket wrench
4
Gaskets
Installation diagram
T M
Retention Mechanism
QTY
3'
4
1
1
2
www.swiftnets.com
Tube insert
Nylon washer
Spring
Nylon screw spacer
2-56 S/S socket screw
for updates.
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for swiftech MCW40-T
Summary of Contents for swiftech MCW40-T
-
Page 1: Parts List
This product is intended for expert users only. Please consult with a qualified technician for installation. Improper installation may result in damage to your components. Swiftech assumes no liability whatsoever, expressed or implied, for the use of these products, nor their installation. - Page 2 We recommend Arctic Silver™ or Arctic Alumina™ epoxy. The MCW40-T™ can be oriented in any position, as needed to clear components on the board, except for one: the inlet and outlet should not be oriented towards the motherboard as the block would otherwise interfere with installation of the graphics card.
- Page 3 Swiftech Inc., 1703 E. 28 St., Signal Hill, CA 90806 T. (562) 595-8009 F. (562) 595-8769 Tube insert Note concerning removal of the tubing: Push in collet squarely against face of fitting. With the collet held in this position, the tube can be removed with a firm pull.
Need help?
Do you have a question about the MCW40-T and is the answer not in the manual?
Questions and answers