Kodak M240 User Manual page 7

6 Plug the AC adapter into a standard electrical outlet.
7 Press the On/Off button on the monitor for more than 2 seconds. A light on the top
of the monitor glows when the monitor is turned on.
8 Turn on the camera.
9 Verify that an image appears on the monitor.
Mount the Camera on a Wall
NOTE: Test monitor reception before mounting the camera on a wall. View the image on the monitor while
someone else adjusts the camera
3 – 6 ft (0.9 – 1.8 m).
CAUTION:
Strangulation Hazard–do not place the camera in the crib or
within 3 ft (1 m) of the baby.
1 Select a wall location for the camera, then drill 2 holes in that location using a
13/64 in. (5.2 mm) drill bit. Use the template provided
2 Insert a wall anchor into each hole, then gently tap the anchors with a hammer
until they are seated (flush-mounted) in the wall.
3 Insert the screws into the anchors, then tighten the screws until
approximately 7/32 in. (5.6 mm) of each screw is exposed.
4 Slide the base of the camera over the screws until the camera locks into place.
5 Connect the AC adapter to the camera (or insert 4 AA-size alkaline batteries).
6 Secure the AC adapter cord to the wall with the mounting clips.
www.kodak.com/go/support
position. Optimal camera-to-subject distance for night viewing is
Quick Start Up
(see page 18).
4