Advertisement
Securing the stand to a countertop
1.
Remove the cover from the neck of the stand 1, and then
slide the base cover forward and lift it off the base 2.
2.
Fasten the stand to a countertop using the appropriate
fastening devices (not provided by HP) for your surface.
3.
Slide the base cover onto the base of the stand 1, and
then replace the neck cover on the neck of the stand 2.
Adjusting the stand
Adjust the display head to the appropriate position for your
application. The suggested working angle is -5 degrees to 80
degrees.
Removing the stand
1.
Lay the RP9 face down on a flat surface covered by a soft
clean cloth.
2.
Push up the release latch on the rear of the display head
1, tilt the stand back 2, and then lift the stand from the
display head 3.
Documentation feedback
HP is committed to providing documentation that meets your
needs. To help us improve the documentation, please send any
suggestions, comments, or errors to doc.feedback@hp.com.
Include the document title and part number (located near the
barcode) when submitting your feedback.
Advertisement
