Water Volume Programming - La Marzocco GB/5 Manual

Water Volume Programming

W at er Vol u me
Pr ogr amm i ng
Display
Press and hold the
1
L a Ma r z o c c o 0 9: 3 0
seconds)
Enter the 5 digit technician password using buttons 1-5 on the group 1 keypad. Once accepted the following
Pas s wo r d 2
?????
appears:
La ng uag e 3 Press the
ENGLI SH
W at e r Vol u me
4 Press the
Pr o g r a mm i n g
on the continuous button will begin lashing. The lashing light indicates the keypad is in programming mode
While in programming mode, press any of the irst 4 buttons. When the desired amount of water has been
5
dispensed, press the same button again to stop the low of water. Continue this same procedure for all buttons
that programming is desired.
Once the irst 4 buttons are programmed, press the
Description
• This parameter allows the operator to
program the water volume (shot volume)
for the individual buttons on the keypad.
Operating Procedure
button on the group 1 keypad until the following is displayed (approximately 10
button on the group 1 keypad until the following appears:
button on the group 1 keypad again. The lights on the irst 4 buttons will light and the light
"Technical" Programming
• The saved program is a number. This
number relates to the number of pulses
the lowmeter delivers to the CPU. Once
the programmed number of pulses is
received by the CPU, the low of water
is stopped.
button to exit programming mode
50