STIEBEL ELTRON CNS Series Installation Manual

THERMOSTAT WIRING AND INSTALLATION GUIDE
CNS, CK, CKT, CK TREND, ALL MODELS
1. Thermostat Wiring Options
There are a number of different options available if you
wish to control your Stiebel Eltron CNS/CK heater with
a room thermostat. There is a limited variety of line
voltage thermostats available to which you can directly
wire your heater. You can also use a transformer/relay
unit so that you can utilize the much wider variety of
low voltage thermostats that are available, including
some of the WiFi capable ones such as Venstar and
Nest. There are also wireless kits available, which
eliminate the need to physically wire the thermostat to
the heater.
When using any type of external thermostat to control
the CK/CNS line of heaters, set the internal thermostat
of the heater to its highest setting, as the cycling of
the heater will now be controlled by the external
thermostat. Do not, however, disable the CK/CNS
heater's internal thermostat, as even when set to its
highest setting, it must still cycle off occasionally to
prevent the external parts of the heater from reaching
hazardous temperatures.
1.1 Line Voltage Thermostats
A line voltage thermostat simply takes the high voltage
signal that is used to power the heater, closes a switch
when the room temperature falls below the setpoint,
which turns the heater on, and opens a switch when
4-Wire Line Voltage
Thermostat 240 V
15 A Minimum
15 A
Double Pole
Circuit Breaker
L1
240 VAC
L2
Fig. 1: 240 V heater with line voltage thermostat.
17 West St., W. Hatfield, MA 01088
1
2
CK/CKT/CNS
240 VAC Units
| 800.582.8423 | 413.247.3380 | fax 413.247.3369
the room reaches the setpoint, turning the heater off.
A line voltage thermostat should not be used when
controlling more than one heater with the same
thermostat.
When wiring this type of thermostat, the line voltage
thermostat is connected to the circuit breaker on the
load panel (breaker box), and the CK/CNS heater is
connected to the line volt thermostat. If using a digital
thermostat, always use a 4-wire model, because the
4-Wire Line Voltage
Thermostat 120 V
15 A Minimum
15 A
Single Pole
Circuit Breaker
L1
120 VAC
L2
Fig. 2: 120 V heater with line voltage thermostat.
internal thermostat of the CK/CNS heaters will turn off
occasionally, even at their highest setting. See figures
1 and 2 for wiring diagrams illustrating the manner in
which to hook up both the 120 V and 240 V heaters to a
line voltage thermostat.
1.2 Low Voltage Thermostats
A low voltage thermostat is the industry standard for
most types of heat sources other than electric resistance
heaters. These devices are typically connected to the
control board of a boiler or furnace, and they operate
on a 24 VAC signal. To utilize this type of thermostat,
it is necessary to use a transformer/relay device such
as the RC840T. A low voltage thermostat can be safely
used to control more than one heater, provided that it
is wired correctly. As is the case with the line voltage
thermostat installation, the internal thermostat of the
heater should be set to its maximum temperature when
info @ stiebel-eltron-usa.com
|
Simply the Best
1
2
CK/CKT/CNS
120 VAC Units
| www.stiebel-eltron-usa.com