Starting Warm Engine - Echo ES250 Operator's Manual

OPERATION

Starting Warm Engine

The starting procedure is the same as Cold Start except DO NOT close the
choke.
1. Stop Switch
Move stop switch (A) away
from the STOP position.
2. Throttle Position Lever
Move throttle position lever
(B) midway between idle and
full throttle positions.
3. Purge Bulb
Pump purge bulb (D) until fuel
is visible and flows freely in
the clear fuel tank return line.
4. Recoil Starter
Place the unit on a flat, clear
area. Firmly grasp throttle
handle with left hand and
rapidly pull recoil starter
handle/rope (E) until engine
fires.
Recoil starter: Use short pulls - only 1/2 ~ 2/3 of rope for starting. Do
not allow the rope to snap back in. Always hold the unit firmly.
Note: If engine does not start after 5 pulls, use Cold Start
Procedure.
26
A
B
E
© 9/2018 ECHO Inc.
ES-250
D
X7501182906