Specifications - Echo ES250 Operator's Manual

ES-250
Do not store in enclosure where fuel fumes may accumulate or
reach an open flame or spark.
2. Place the stop switch or lever in the "OFF" position.
3. Remove accumulation of grease, oil, dirt and debris from exterior of
unit.
4. Perform all periodic lubrication and services that are required.
5. Tighten all the screws and nuts.
6. Drain fuel tank completely. Press purge bulb 6 -7 times to remove
remaining fuel from carburetor then drain the tank again. Close choke,
start and run the engine until it stops due to lack of fuel.
7. Allow engine to cool. Remove the spark plug lead from the spark plug.
Remove the spark plug. Pour 7 cc (0.25 oz.) of fresh, clean, two-stroke
engine oil into the cylinder through the spark plug hole.
8. Pull the recoil starter handle 2-3 times to distribute the oil inside the
engine.
9. Observe the piston location through the spark plug hole. Pull the recoil
handle slowly until the piston reaches the top of its travel and leave it
there.
10. Install the spark plug. Connect the spark plug lead to the spark plug.
11. Remove blower pipe assembly from unit.

SPECIFICATIONS

MODEL
Length
Width
Height
Weight (dry)
Engine Type
Bore
Stroke
Displacement
Exhaust
X7501182906
© 9/2018 ECHO Inc.
330 mm (13.0 in.) (w/o pipes)
280 mm (11.0 in.)
345 mm (13.6 in.)
4.3 kg (9.5 lb.)
Air cooled, two-stroke, single cylinder gasoline
engine
34.0 mm (1.34 in.)
28.0 mm (1.1 in.)
25.4 cc (1.55 cu. in.)
Spark arrestor muffler or spark arrestor muffler with
catalyst
SPECIFICATIONS
ES-250
43