Table of Contents
Advertisement
STARTING WARM ENGINE
The starting procedure is the same as Cold Start except DO NOT close
the choke.
NOTE
If engine does not start after 5 pulls, use Cold Start Procedure.
WARNING
Blades should not move at idle. If blades move, readjust carburetor
according to Carburetor Adjustment instructions in the manual or
see your ECHO dealer, otherwise serious personal injury may result.
1.
Stop Switch -Start/Run.
Move Stop Switch button (A) away from the STOP position.
2.
Primer - Pump Bulb.
Pump primer bulb (C) until fuel is visible and flows freely in the
clear fuel tank return line. Pump bulb an additional 4 or 5 times.
3.
Starting
Lay unit on a flat, clear area and pull starter handle/rope (D) until
engine fires.
DANGER
H
C
EDGE
O
'
M
PERATOR
S
A
C
D
LIPPER
13
ANUAL
Advertisement
Table of Contents
