Registering Your Shark Hd4 - Next Wave Automation CNC Shark HD4 Owner's Manual

WARNING: The axis cable connectors should never be disconnected or re-connected while there is
power to the Controller Interface. Doing so can damage the stepper driver board inside the Controller
Interface.
The CNC Shark HD4 machine's hardware is now completely setup and is ready for basic operation
testing. You must setup the CNC Shark HD4 software before you can completely test your CNC Shark
HD4 machine.

Registering your Shark HD4

Once you power up your CNC Shark HD4, you will see a screen like below. Hit continue.
Next you will see your CNC Shark HD4's serial number, and firmware information. Record this serial
number into your manual on Page 2 then press OK.
April 2018
CNC Shark HD4 Welcome Screen
CNC Shark HD4 Serial Number
CNC Shark HD4 | 13