Cnc Shark Controller And Lcd Pendant - Next Wave Automation CNC Shark HD4 Owner's Manual

The core components of the CNC Shark HD4 are shown in the figure below.
X - axis
motor
Y - axis motor

CNC Shark Controller and LCD Pendant

The CNC Shark LCD Pendant controls the movement of the X, Y, and Z axis as well as runs the project's
tap file saved from the Vectric design software when input via a flash drive. The LCD Pendant is designed
to be a standalone unit so that it is no longer necessary to expose your computer to a dusty shop
environment. However, in the event you want to run it from your computer the Controller Interface may
also be connected using a USB cable plugged into a USB 2.0 capable plug. This function will require you
to download and use the CNC Shark Control Panel software (check online for the latest version) used to
communicate to the controller. Then, just like the LCD Pendant you can use this interface to jog
(position) the gantry and router, load a project (tap) file, and run the project.
April 2018
Z - axis
motor
CNC Shark HD4 Core Components
Gantry
Router
Carriage
Interlocking
T - track
Clamping base
CNC Shark HD4 | 9