Kenwood CM460 series Manual page 6

5 For each cup of coffee required,
place one level spoon of filter coffee
into the permanent filter. Adjust
quantity to taste.
6 Close the lid.
7 Plug into the power supply.
CM450/CM460 series
G Press the ON/OFF button, the light
will come on and brewing will
commence.
CM550 and CM560 series
G Press the Auto/ON/OFF button
twice for coffee to be produced
straight away, the light will come on
and brewing will commence. If you
want to use the automatic brew
facility follow the instructions to set
the clock and to programme
automatic brew.
8 To dispense coffee, press the coffee
dispensing lever with a cup and
coffee will flow out. Never press the
dispensing lever with your hand. To
stop the flow remove the cup.
Coffee may be dispensed during and
after brewing.
G To preserve heat and flavour, DO
NOT open the lid during or just after
brewing.
9 The BrewMaster will keep the coffee
warm and then automatically switch
off after 2 hours. To manually switch
off earlier, press the ON/OFF button.
to make tea
Follow the procedure for making
coffee using tea leaves instead of
filter coffee.
Place the desired amount of loose
tea into the permanent filter using
the spoon provided. The amount
will vary depending upon the type of
tea used and individual tastes but as
a guide use 4 - 6 spoons of loose
tea per maximum capacity of water.
Some experimentation will be
necessary to obtain the desired
result.
For best results we recommend that
only the required amount of tea is
made at one time and that the tea is
drunk within half an hour of brewing.
You may notice fragments of tea
leaves in the dispensed tea – this is
normal.
After use always wash the parts
thoroughly. If alternating between tea
and coffee making, take extra care
to ensure the coffee tank and
permanent filter are well washed and
rinsed.
You may wish to purchase an
additional permanent filter and coffee
tank to have dedicated parts for tea
and coffee making.
CM550 and CM560
series only
to set the clock.
1 Plug in the BrewMaster. The
numbers on the clock will flash until
the time of day is set or one minute
elapses.
2 To set the time of day:
Press the 'H' button to set the
G
current hour with AM or PM.
Press the 'M' button until you reach
G
the current time.
to select 12 or 24 hour
clock.
To change from a 12 hour clock
(AM/PM) to a 24 hour clock or vice
versa. Press the H and M buttons
simultaneously for 2 seconds.
to programme automatic brew
1 Set the clock to the correct time of
day.
2 Press the 'Prog' button and the
digits will flash.
3 Press the H and M buttons until the
desired brewing time is reached.
4 Press the 'Prog' button to confirm
setting. The digits will stop flashing
and return to the set time of day.
3