Trouble Shooting; Fuse Replacement; Battery Replacement - Samsung SVP-6000N/P User Manual

Trouble shooting / Fuse and battery replacement
No image appears
- Check if the resolution of the output device corresponds to that of the video
presenter.(for example, when the maximum resolution of a projector is XGA and if
the video presenter is set to SXGA, then no image appears.)
- Check if the input selection of the output devic is appropriate.
- Check if the iris control is adequate
- Check if the VGA cable is connected to the VGA output terminal correctly.
- Check if there is any problem with the fuse
Remote control is not working
- Check the battery of the remote control.
Replace it with a new one.
- Check if the lower lamp is turned on
- Adjust the lens to face the film directly
- Check if the NEGA/POSI button is selected properly
The light is not turned on right away after
the [LIGHT] button is pressed
It is a normal phenomenon occurring because the protection circuit is in operation to protect
the lamp

Fuse replacement

1
Take out the fuse holder

Battery replacement

Open the battery compartment lid
1
at the back of the remote control
No image from a slide film or
a negative film
2
Take out the fuse and replace it
• Fuse type:2A, 250V
Insert the batteries so
2
that their with a new one
• Battery type:AAA type 1.5V
No communication
between the PC and USB.
- Make sure the operating system is Windows 98. It doesn't
work on Windows 95.
- For other detailed information, please refer to the program
manual supplied with the product.
The image is out of focus
- Check if the adaptor lens is attached properly for the purpose.
(Be sure to attach the adaptor lens in the camera mode)
- Check if the distance from the object is too short.
If there are problems,
please contact the store
you purchased the product
or our distributor nearest
you.
3
fuse
Spare fuse
3
Put the fuse holder back
Close the lid
page16