Installation And Wiring; Mounting The Module; Fig. 2 Mounting Dimensions, Curtis 1352 Exm Module - Curtis 1352 Manual

2 — INSTALLATION & WIRING
2
+
C A U T I O N
Fig. 2
Mounting
dimensions, Curtis 1352
eXm module.
4

INSTALLATION AND WIRING

MOUNTING THE MODULE

The outline and mounting hole dimensions for the 1352 eXm module are shown
in Figure 2. The module should be mounted using two #10 or M5 screws.
Care should be taken to prevent contaminating the connector area
before the mating 14-pin connector is installed. Once the system is plugged
together, the eXm meets the IP65 requirements for environmental protection
against dust and water. Nevertheless, in order to prevent external corrosion
and leakage paths from developing, the mounting location should be carefully
chosen to keep the module as clean and dry as possible.
Status
LEDs
65 (2.6)
39
(1.5)
Dimensions in millimeters (and inches)
If the outputs will be used at or near their maximum ratings, it is rec-
ommended that the module be mounted to a good heatsinking surface, such
as an aluminum plate.
6.3 (0.25) dia.,
2 plcs
130 (5.2)
Curtis 1352 eXm Manual,
100
(3.9)
87
(3.4)
Rev. D