Remote Control; Installing Batteries In The Remote Control - Samsung HLN4365W Instruction Manual

BP68-00142A-1 5/27/03 10:09 AM Page 16
Your New Wide TV

Remote Control

You can use the remote control up to a distance of about 23 feet from the TV. When using the remote,
always point it directly at the TV. The remote control can also operate your VCR, cable box, and DVD
player.
1. POWER 16. Still
Press to stop the action during a particular
Turns the TV on and off.
scene. Press again to resume normal video.
2. +100
17. Fav.CH (Favorite
Press to select cable channels over 100 on
Channel)
TV.
Press to switch between your favorite chan-
nels.
3. Menu
18. S.Mode
Displays the main on-screen menu.
Adjust the TV sound by selecting one of the
4. CH(Channel) and
preset factory settings (or select your per-
VOL(Volume)
sonal, customized sound settings.)
Controls volume, channel selection.
19. P.Mode
Adjust the TV picture by selecting one of the
5. Mute
preset factory settings (or select your per-
Press to mute the TV sound.
sonal, customized picture settings.)
6. Display
20. VCR controls
Press to display information on the TV
Controls VCR tape functions: Rewind, Play,
Fast Forward, Stop, Pause.
screen.
21. PIP controls
7. Aspect
Source ; Press to select one of the available
Press to change the screen size.
signal sources for the PIP window.
8. Surround
Scan; Press to scan the memorized
Press to hear the Dolby surround effect.
channels.
9. MTS(Multichannel
Locate; Press to move the PIP window to
Television Stereo) any of the four corners of the TV screen.
Press to choose stereo, mono or Separate
Swap; Exchanges the video signal that is
Audio Program (SAP broadcast).
currently displayed on the main screen with
the signal in the PIP window.
10. Mode
Size; Press to make the PIP window larger
Selects a target device to be controlled by
or smaller.
the Samsung remote control (i.e., TV, VCR,
Cable, or DVD).
CH(PIP); Displays the available channels in
sequence. (These buttons change channels
11. Pre-ch
in the PIP window only.)
Tunes to the previous channel.
22. V.chip
12. TV/Video Press to set up and activate the parental
locks.
Press to display all of the available video
sources (i.e., TV, VCR, DVD, DTV, PC). 23. Set
Used during set up of this remote control,
13. Joystick
so that it will work compatibly with other
Use to highlight on-screen menu items and
devices (VCR, cable box, DVD, etc.)
change menu values.
24. Sleep
14. DNIe Press to select a preset time interval for
automatic shutoff.
Activates DNIe (Digital Natural Image
25. Add/Erase
engine).
Press to add or erase channels in the TV's
15. PIP
memory.
Activates picture in picture.
Use the Add/Erase button to
memorize/erase the fine tuning after fine
tuning channels.
16

Installing Batteries in the Remote Control

With normal use, the batteries in the remote control should last about a year. If you notice a performance
degradation while using the remote, the batteries may need to be replaced. Make sure you replace both
batteries and do not mix old and new batteries in the remote control. If you won't be using the remote
control for a long time, remove the batteries and store them in a cool dry place.
Slide the back cover all the way out
1
to open the battery compartment of
the remote control.
Install two AAA size batteries.
2
Make sure to match the "+" and
"–" ends of the batteries with the
diagram inside the compartment.
Slide the cover back into place.
3
17