BP68-00142A-4
5/27/03
10:08 AM
Page 68
Special Features
Changing the Size of the PIP image
68
Press the Menu button. Move
1
the joystick down to select
PIP, then press the joystick to
enter. Quick way to access PIP
Size: Just press "Size" on the
remote control.
Move the joystick down to
2
select "Size".
Move the joystick to the right
3
or left to select "Large",
"Double1", "Double2" or
"Small".
Note: Double function doesn't
operate In the Component,
PC, DVI mode.
Press Menu to exit.
4
Changing the Picture-in-Picture Channel
After you set the PIP signal source (antenna or cable), it is easy to change channels.
Press the Menu button. Move
1
the joystick down to select
PIP, then press the joystick to
enter. Quick way to access PIP
channel: Just press "PIP CH
(L,M)" on the remote control.
Move the joystick down to
2
select "Channel".
Move the joystick to the right
3
or left to change the channel
of the PIP image.
Press Menu to exit.
4
NOTE
• The PIP channels are not available when RF is set to ANT-B.
(The PIP channels link to ANT-A).
69