How To Use Your Vacuum Cleaner; How To Use Hand Vacuum And Accessory Tools - Eureka NEC120 series Owner's Manual

NEC120_02155120_WMT_rev1.qxp_Layout 1 12/11/17 11:17 AM Page 7
How to use cleaner for
cleaning floors
1. Click power button once to start (Fig 1).
2. Using motorized floor nozzle, glide
back and forth on area to be cleaned.
Avoid oversized or sharp items (such
as screws) with cleaner.
3. Twist wrist to engage swivel function.
4. When done, click power button once
to stop motor.
Empty dust cup after every use
There are two ways to empty the
dust cup:
1. Hold cleaner over waste basket. Press
lever to release bottom lid of dust cup
to empty debris (Fig. 2).
2. Remove dust cup from hand vacuum
by twisting to 'unlock'
(Fig. 3). Once emptied, reattach dust
cup by lining up arrow
position. Twist dust cup until arrow
lines up with 'locked'
How to use hand vacuum
and accessories
The hand vacuum can be used with
or without tools.
• To use without tools, press release
button and remove wand. Collect
debris directly with hand vacuum
nozzle (Fig. 4).
• To use tools with wand, press release
button to remove motorized floor
nozzle. Slide tool onto end of wand
until it clicks (Fig. 5).
• To use tools with hand vacuum only,
press release button to remove wand.
Slide tool onto hand vacuum until it
clicks.
position
and 'unlock'
position.
CAUTION
1
Power button
2
4
Crevice tool: Cleans
hard-to-reach areas
such as corners,
baseboard edges,
dryer vents,
chairs and
sofas.
3
5
7
www.eureka.com