Table of Contents
Advertisement
4.3. Keys
Operation
+
+
+
+
+
* To change the digital zero operation, use the function (Cf11).
To protect against accidental operation, press the
hold the
4.4. Operation mode
- Upper / lower limit setting mode
Use this mode to set the upper and lower limit of the comparator.
- Calibration mode
Use this mode to perform zero and span calibration with an actual load.
- Function setting mode
Use this mode for setting functions.
- Check mode
Use this mode to confirm input and output operation.
Press to proceed to the upper limit value setting mode.
When inputting a numerical value, press to change the polarity.
Press to proceed to the lower limit value setting mode.
When inputting a numerical value, press to cancel the setting.
Press to turn the digital zero on.
When inputting a numerical value, press to shift the position
of the blinking digit to the right or change the function group.
Press to turn the digital zero off.
Press to turn holding on or off.
When inputting a numerical value, press to change the
blinking digit or change the function parameter.
Press to output the serial data (print).
When inputting a numerical value, press to enter the setting.
Press to proceed to the calibration mode.
Press to proceed to the function selection mode.
Press to proceed to the selection mode in the check mode.
key for one or more seconds to turn the digital zero on.
Function
+
11
keys or press and
Advertisement
Table of Contents
