Motorola SC 4812ET RF Hardware Installation Manual page 153

Figure D-6: Connecting Power Cables
Apr 2001
SC
TM
V0D.03
SC 4812ET/SC 614 BTS DC Power Sharing
LUG COVER
POWER
INPUT
STUD
Route the cables through the rubber boot BEFORE
crimping lug onto wire or damage to the boot can occur.
Installation Procedure
S
Before starting the procedure, ensure that the Power
Cabinet main DC breakers are turned "OFF".
Follow the procedure in Table D-6 to install the DC power cables (refer
to Figure D-6 and Figure 5-1).
4812ET RF and Power Cabinet Hardware Installation Manual
CAUTION
WARNING
Do NOT wear a wrist strap when servicing the power
supplies or power distribution cabling. Serious personal
injury can result.
CAUTION
DRAFT
– continued
CABLE
GROMMET
M10 NUT (17 mm Hex
Driver Required)
M10 LOCK WASHER
M10 FLAT WASHER
CRIMP LUG
FEED COVER
(Do not remove)
ENCLOSURE
BASE
153
D