Motorola SC 4812ET RF Hardware Installation Manual page 124

Installing RGPS
A
– continued
Step
3 Insert the prepared cable into the pipe (see Figure A-1).
4 Connect the RGPS head to the cable. To secure the connection, tighten the spinning connector flange
(located on the prepared cable) see Figure A-1.
5 Insert the pipe into the threaded neck on the RGPS head and hand tighten firmly.
6 Place the assembly into the mounting brackets and secure.
7 Route the cable down to the RF cabinet.
8 Install the cable into the punch block. The punch block pin locations for the cable are listed in Chapter
5.
Figure A-1: Remote GPS Mounting
124
Table A-1: Installing the RGPS
WALL MOUNTING
BRACKETS (2)
SC 4812ET RF and Power Cabinet Hardware Installation Manual
TM
Action
CABLE TO PUNCH
BLOCK IN RF CABINET
DRAFT
CLAMP BRACKETS (2)
Apr 2001
V0A.03