Specifications - Makita LS0815FL Instruction Manual

SPECIFICATIONS

Model
Blade diameter
Blade thickness
Hole diameter
- For all countries other than European countries
- For European countries
Max. Miter angle
Max. Bevel angle
Max. Cutting capacities (H x W) with 216 mm in diameter
Rated voltage
Rated input
-1
No load speed (min )
Laser Type (LS0815FL only)
Dimensions (L x W x H)
Net weight
Safety class
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
･
Read instruction manual.
･
DOUBLE INSULATION
･
To avoid injury from flying debris, keep
holding the saw head down, after
making cuts, until the blade has come
to a complete stop.
･
When performing slide cut, first pull
carriage fully and press down handle,
then push carriage toward the guide
fence.
･
Do not place hand or fingers close to
the blade.
･
Adjust sliding fences clear of blade and
blade guard properly.
･
LASER RADIATION: Do not stare into
beam. Direct laser beam may injure
your eyes.
Miter angle
0°
45°
60° (right)
45° (left)
50 mm x 305 mm
50 mm x 215 mm
-
For all countries other than European countries•••14.1 kg
END223-4
Intended use
The tool is intended for accurate straight and miter
cutting in wood. With appropriate saw blades, aluminum
can also be sawed.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
8
Bevel angle
5° (right)
60 mm x 305 mm
-
-
1,400 w, S6 40% 5 min
Red Laser 650 nm,
755 mm x 450 mm x 488 mm
For European countries•••LS0815F 14.1 kg
･
Only for EU countries
Do not dispose of electric equipment
together with
material!
In observance
Directive, on Waste
Electronic Equipment
implementation in accordance with
national law, electric equipment that
have reached the end of their life must
be collected separately and returned to
an environmentally
recycling facility.
LS0815F / LS0815FL
216 mm
1.5 - 2.5 mm
25.4 mm
30 mm
Left 50° Right 60°
Left 48° Right 5°
0°
65 mm x 305 mm
65 mm x 215 mm
65 mm x 150 mm
220 - 240 V, 50-60 Hz
5,000
1 mW (Laser Class 2)
••• LS0815FL 14.2 kg
/II
household waste
of the European
Electric and
and its
compatible
ENE006-1
ENF002-2