Download  Print this page

Advertisement

Cutout Tool
MODEL 3706
I N S T R U C T I O N
WARNING:
For your personal safety, READ and UNDERSTAND before using.
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
DOUBLE
INSULATION
M A N U A L
004550

Advertisement

Table of Contents

   Summary of Contents for Makita 3706

  • Page 1 Cutout Tool MODEL 3706 004550 DOUBLE INSULATION I N S T R U C T I O N M A N U A L WARNING: For your personal safety, READ and UNDERSTAND before using. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
  • Page 2: Specifications

    Responsible manufacturer: Power supply Makita Corporation Anjo Aichi Japan The tool should be connected only to a power supply of the same voltage as indicated on the nameplate, and can only be operated on single-phase AC supply. They...
  • Page 3: General Safety Rules

    GENERAL SAFETY RULES GEA001-3 WARNING: Read all instructions. Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury. The term “power tool” in all of the warnings listed below refers to your mains-operated (corded) power tool or battery- operated (cordless) power tool.
  • Page 4: Additional Safety Rules

    19. Store idle power tools out of the reach of chil- the manner intended for the particular type of dren and do not allow persons unfamiliar with power tool, taking into account the working con- the power tool or these instructions to operate ditions and the work to be performed.
  • Page 5: Functional Description

    FUNCTIONAL CAUTION: DESCRIPTION • Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool. Adjusting depth of cut 001624 To adjust the shoe, turn the thumb screw to loosen. Slide the shoe to the desired position and tighten the thumb screw securely.
  • Page 6 Changing the collet cone 004554 CAUTION: • Use the correct size collet cone and adapter for the bit which you intended to use. • Do not tighten the collet nut without inserting a bit, or the collet cone will break. To change the collet cone, loosen the collet nut and remove.
  • Page 7 NOTE: When using this tool, the rotating action causes the tool to pull. The less pressure applied to the tool causes less pull and provides a more accu- rate cut. Excessive pressure or fast cutting can cause the bit to dull or break premature.
  • Page 8 001635 cut in a clockwise direction. 1. Knob Vacuum cover Cleaner operations can be performed by connecting the cutout tool to Makita vacuum cleaner or dust collector. Installing vacuum cover 001636 Loosen the thumb screw and remove the shoe. Attach the vacuum cover, and fasten it securely using the thumb screw.
  • Page 9 Connecting to Makita vacuum cleaner or dust collector 001639 Connect the hose of a vacuum cleaner/dust collector to the dust nozzle. When connecting to Makita vacuum cleaner, an optional hose 28 mm in inner diame- ter is necessary. 1. Vacuum cover 2.
  • Page 10 CAUTION: • These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or attachment for its stated purpose.
  • Page 11 Memo...
  • Page 12 Makita Corporation Anjo, Aichi, Japan 884373C223...

Comments to this Manuals

Symbols: 0
Latest comments: