Samsung CLX-3160 User Manual page 79

Message Meaning
Stop/Clear has
[Stop Pressed] been pressed during
an operation.
Your machine's
memory has
Cancel?
become full while
Yes
trying to store an
original into memory.
Connection with the
Connection Error
SMTP server failed.
Data Read Fail Time expired while
Check USB Mem. reading data.
Data Write Fail Storing to the USB
Check USB Mem. memory failed.
Deve Home Sensor There is a problem
Error in the fuser unit.
The loaded original
Document Jam has jammed in the
ADF.
The front cover or
Door Open rear cover is not
securely latched.
You entered an
Enter Again
unavailable item.
The selected file
File Format
format is not
Not Supported
supported.
There is a problem
Fuser Fan
in the cooling fan of
Locked
the machine.
Suggested solutions
Try again.
To cancel the fax job,
press the OK button
to accept Yes.
If you want to send
those pages that
have been
successfully stored,
press the OK button
to accept No. You
should send the
remaining pages
later, when memory is
available.
Check the server
settings and the
network cable.
Try again.
Check the available
USB memory space.
Unplug the power
cord and plug it back
in. If the problem
persists, please call
for service.
Clear the jam. See
page 14.1.
Close the cover until it
locks into place.
Enter the correct item
again.
Use the correct file
format.
Open and then close
the front cover.
14.6
Message Meaning
You have tried to
select a group
location number
where only a single
Group Not location number can
Available be used, such as
when adding
locations for a
Multiple Send
operation.
The color toner
Install
cartridge is not
[Color] Toner
installed.
The corresponding
Install
part of the machine
[Part]
is not installed.
The color toner
Invalid cartridge you have
[Color] Toner installed is not for
your machine.
The color part of the
Invalid
machine is not for
[Part]
your machine.
The receiving fax
machine did not
Line Busy
answer or the line is
already engaged.
Low Heat Error
There is a problem
in the fuser unit.
Cycle Power
A problem has
LSU Hsync Error
occurred in the LSU
(Laser Scanning
Cycle Power
Unit).
A problem has
LSU Motor Error
occurred in the LSU
(Laser Scanning
Cycle Power
Unit).
Main Motor There is a problem
Locked in the main motor.
<Troubleshooting>
Suggested solutions
Use a speed dial
number or dial a
number manually
using the number
keypad.
Install the color toner
cartridge.
Install the part into
your machine.
Install the a
Samsung-genuine
color toner cartridge
designed for your
machine.
Install the a
Samsung-genuine
part designed for your
machine.
Try again after a few
minutes.
Unplug the power
cord and plug it back
in. If the problem
persists, please call
for service.
Unplug the power
cord and plug it back
in. If the problem
persists, please call
for service.
Unplug the power
cord and plug it back
in. If the problem
persists, please call
for service.
Open and then close
the front cover.