Setting Cooling Temperatures; Automatic Ice And Water Dispenser - Electrolux EHE6899 User Manual

SETTING COOLING TEMPERATURES

NOTE: The recommended settings for a product
installed in a kitchen is 3˚C for the fresh food
compartment and -17˚C for the freezer.
IMPORTANT
If your product has food freezing in the fresh food
compartment, increase the temperature setting 1 or 2
degrees.
If you place food within 1 inch in front of the air ports,
there may be the chance of freezing food.
NOTE: Control features and alarms may vary by
model.
Alerts and Alarms
Water Filter
When illuminated, the water filter needs to be replaced.
Change the water filter every 6 months or when 120
gallons of water has been dispensed. To reset, press
and hold button for 3 seconds. Tone will sound once it
has been reset.
Air Filter Installation
First operation the refrigerator need to installation the
air filter which storage at crisper left side and follow
installation method as below.
Carbon activated air filter
1) Remove plastic wrap.
2) Install filter according to your refrigerator's
use&care guide.
3) Reset filter reminder light on your refrigerator.
4) Replace filter every 6 months.
When illuminated, air filter needs to be replaced.
Change the air filter every 6 months. To reset, press and
hold button for 3 seconds. Tone will sounds once it has
been reset.
Door Open
If a door has been left open for 5 minutes or more, an
alarm will sound and the door open indicator will
illuminate on the display. The alarm can be turned off
by closing the door or pressing any key. Control panel
will return to normal operations after the door is closed.
Error tone
An alarm will sound if the user tries to make a selection
that is not available.
Automatic Ice & Water Dispenser
Using the ice maker after installation
Before making ice for the first time, be sure to prime
the water supply system. Air in new plumbing lines
can result in two or three empty ice maker cycles.
Furthermore, if the system is not flushed, the first ice
cubes may be discolored or have an odd flavor.
Priming the water supply system
CAUTION
For proper dispenser operation, recommended
water supply pressure should fall between 30 psi
and 100 psi. Excessive pressure may cause the
system to malfunction.
1. Begin filling the system by pressing and holding a
drinking glass against the dispenser.
2. Keep the glass in this position until water comes
out of the dispenser. It may take about 1½
minutes.
3. Continue dispensing water for about four minutes
to flush the system and plumbing connections of
any impurities (stopping to empty the glass as
necessary).
Dispenser
NOTE: The water dispenser has a built-in device
that shuts off the water flow after three minutes of
continuous use. To reset this shutoff device,
simply release the dispenser paddle.
Only the first 26 ounces (750 ml) of dispensed
water is chilled.
15