Cartridge Kit Preparation; Loading The Cartridge Kit - TECHCON SYSTEMS TS6500 User Manual

6.3 Cartridge Kit Preparation

Injection Kit: The TS6500 Mixer has an automatic injection
device that will inject the hardener into the catalyst during the
mixing operation. However the valve in the mix rod needs to be
opened before placing the kit in the machine.
instructions to open the valve.
1. Insert the ram rod into the mix rod
2. Push the ram rod to force the valve opened
3. Follow instructions in section 6.4 to mix the injection kit
Mix Rod
Figure 9.0 Injection Kit
Barrier Kit
1. Remove barrier tape from the kit
2. Pull the mix rod down to the fullest extend to remove the foil
from the dasher.
3. Follow instructions in section 6.4 to mix the barrier kit
Mix Rod
Dasher
Figure 10.0 Barrier Kit
13
Follow below
Valve
Barrier tape
Foil

6.4 Loading the Cartridge Kit

Note:
a. The unit is setup to mix cartridge kit with 8"(203mm) mix
rod. To mix cartridge kit with 6"(152mm) mix rod, the
spindle extension needs to be installed. Refer to section
6.5 for instructions.
b. The TS6500CIM-6 is setup to mix 6 oz. (177ml) cartridge
kit. To mix 2.5 oz. (74ml) or 8.0 oz.(237ml) kit, Refer to
section 12. for instructions.
1. Open the safety cover (Fig. 2, 12).
2. Load the cartridge kit into the cartridge holder (Fig. 2, 2).
3. Pull the mix rod to the fullest extend then align the two
through holes of the rod to the drive spindle (Fig. 2, 6).
4. Insert the plunger assembly (Fig.2,16) into the cartridge
holder with the plunger sit properly inside the cartridge.
5. Align the dowel pins of the plunger assembly with the
bayonet slots in
counterclockwise until it locked in.
6. Connect the air hose into the plunger air inlet (Fig. 2, 4).
7. Close the safety cover.
Lock Dowel
pins in the
slots
Mix Rod
Figure 11.0 Loading the Cartridge Kit
the cartridge holder and
Plunger
Assembly
Cartridge
Holder
Plunger Air Inlet
Drive Spindle
14
turn