Table of Contents
Advertisement
4.
Push to select the necessary probe type (see the
figure below). Push to store the change and go to
the Main Menu.
The default probe type is PT100-385.
SELECT RTD PROBE TYPE
5.
Connect the RTD Probe.
Note
hix036.eps
The standard probe has a 10-inch insertion depth with a
¼-inch diameter stainless steel sheath. See Figure 5.
The factory default type is PT100-385 so if the
Product is used with the Fluke 720 RTD Probe
(pn 4366669), it is not necessary to set the
probe type. Connect the probe to the Product
and configure the display to read temperature.
The display shows "OL" when the measured
temperature is outside the nominal
measurement range of the RTD function (below
°
°
-40
C or above 150
C).
Pressure Calibrator
Product Features
Note
23
Advertisement
Table of Contents
