General Limitations - ADInstruments PowerLab Owner's Manual

Galvanic skin response amplifier
Table of Contents

Advertisement

Hardware Warranty Limitations
This warranty applies only to the ADI hardware specified in this document and used under
normal operating conditions and within specification. Consumables, electrodes and accessories
are not covered by this warranty. Third party equipment may be covered by the third party
manufacturer's warranty. To the extent that ADI has the right to pass through any third party
manufacturer warranties to Purchaser it will do so to the extent it is able to do so. Copies of
applicable third party manufacturer warranties, to the extent they exist, are available upon
request. The warranty provided hereunder does not cover hardware modified in any way,
subjected to unusual physical, electrical or environmental stress, used with incorrectly wired or
substandard connectors or cables, or with the original identification marks altered. Tampering
with or breaking of the Warranty Seal will also void the warranty.
Product Types & Warranty Term
ADI manufactured products covered by a five (5) year warranty
ADI manufactured products covered by three (3) year warranty
ADI manufactured products covered by one (1) year warranty
Third Party Products (Including Transducers)
Accessories and Consumables

General Limitations

ADI products are produced to high standards, and should perform as described in the supplied
documentation. There is a limited hardware warranty, and technical support is provided for
all ADI products. Nevertheless, since ADI products could be affected by external factors (for
instance, the computer system on which they run and other hardware and/or software provided
by third parties), absolute performance and reliability of products and the overall solution
cannot be guaranteed. No warranty, either expressed or implied or statutory, other than that
expressly contained in this Agreement, is made in respect to ADI products or software, third
party products or software, the overall solution or otherwise. The Purchaser therefore assumes
all risks as to the performance and reliability of the products, the software, the solution and the
results gained using them. ADI neither assumes or authorizes any person to assume on its behalf
any liability in connection with the sale, installation, service or use of its products. ADI shall not
be held responsible for special, consequential or punitive damages of any kind arising out of
32
1
Data Acquisition Units: PowerLab 35 series with PL prefix
2
Front-ends: ADI Front-end Signal Conditioners with FE prefix.
3
Data Acquisition Units: PowerLab 26 series with ML prefix
4
Front-ends: ADI Front-end Signal Conditioners with ML prefix.
5
Pods: The entire range of ADI Pod Signal Conditioners.
6
Specialized Data Recorders: Metabolic Systems (e.g., ML240 PowerLab/8M Metabolic
System)
7
Instruments: Blood FlowMeter, Gas Analyzers, NIBP System (excluding transducers), STH
Pump Controller.
Products not manufactured by ADI are covered by the manufacturer's warranty.
Accessories and Consumables are not covered by any type of warranty.
Owner's Guide

Advertisement

Table of Contents
loading

This manual is also suitable for:

Fe231Fe232Fe234Fe238

Table of Contents