Rabbit Air MinusA2 SPA-780N Quick Start Manual

Quick Start Guide
Let's Begin!
1. Remove the front panel by lifting
from the bottom and pulling up.
4. Remove the white Medium Filter from the black frame to discard the plastic wrapping. Return the filter to its frame.
5. Remove HEPA Filter and discard plastic
wrapping.
7. Pull out the Activated Carbon Filter and discard
plastic wrapping.
Scan this QR code to watch our MinusA2 filter maintenance
video, or watch it online at: www.rabbitair.com/video
Do not operate the unit until completing these steps first
Your customized filter will be packaged in plastic outside of the unit.
Set the filter aside for later installation (step 6).
2. Remove the filter case by grasping
the handles on either side and pulling
forward. Lay the filter case on a flat
surface.
Initial set up for MinusA2 SPA-780N
3. Pull the tabs on the front of
the Pre-filter to remove it.
6. Remove the empty Customized Filter frame from
the case. Locate the Customized Filter set aside from
earlier and remove it from its plastic wrapping.
Insert the filter into its frame. Make sure the front of
the filter is facing up. See Customized Filter chart to
identify the front of your filter.
Next Page