Disassembly For Repair - Kenwood KDC-MP425 Service Manual

How to Disassemble (PANEL ASSY)
1) Remove four screws (A).
2) While holding the section (B) indicated with arrows, pull and
remove PANEL ASSY.
3) Pull SWITCH UNIT (C) as indicated in the diagram and re-
move knob (D).
(The knob (D) is attached to the rotary with hook (E) and it
is not possible to remove hook (D) only.)
C

DISASSEMBLY FOR REPAIR

A
x2
A
B
B
B
B
D
E
How to install knob (SRC)
1) Place knob (F) and knob (G) in the positions indicated in
the diagram below.
2) While keeping these positions, use a piece of adhesive tape
(H) to hold knobs in position, as shown in the diagarma.
3) Set the rotary (J) position as shown in the diagram.
4) While keeping the letters "SRC" horizontally in position, set
it to the rotary on the panel.
5) Remove the adhesive tape (H).
x2
H
J
KDC-MP425/MP6026
KDC-W6027/W6027Y
F
G
3