Silk'n Infinity H3102 User Manual page 24

Approximately 1 second after pressing the control button, the
5.
ready/skin tone warning indicator light (green) will turn on.
The device is now ready for you to trigger the first pulse at the
lowest energy level. Always start at energy level 1.
EN
6. Select the energy level you are most comfortable with.
Place the treatment surface on the skin and press the pulse
7.
button to deliver one pulse. Make sure your hand touches the
base electrode together with the pulse button.
a
Press the pulse button.
8.
y
y
y
Remove the treatment surface from the treated area of skin.
9.
Decide if you wish to treat the area by Gliding or Pulsing (see
10.
section "4.4 Pulsing and gliding").
y
y
If you do not make hand contact with the base electrode no
galvanic treatment circulation will be emitted.
The device first determines the skin color. If the skin color is light
enough for safe application, the device will activate the galvanic
circulation. You might feel a slight tingling sensation. This is
completely normal. The galvanic treatment works to enlarge your
pores for a better application of the treatment.
Directly afterwards, the device will flash a pulse of light onto your
skin, and the ready/skin tone warning indicator light will turn
off. You will see a bright flash of light and simultaneously hear a
popping sound, which is a normal noise for the device. You will
feel a mild sensation of warmth and tingling. The device will
immediately recharge for the next pulse.
After a few seconds the ready/skin tone warning indicator
light will turn on again and start blinking slowly when pressed
against the skin.
If you are Pulsing, place the treatment surface on an adjacent
part of your skin, and trigger a pulse.
If you are Gliding, hold the pulse button down continuously
and slide the device smoothly along the treated area.
22