Step 5 - Complete Installation - Haier HCC2220BEB Installation Instructions Manual

Ungrounded Neutral
Junction Box (not provided)
A
Black Wires
B
Red Wires
C
Cable from Cooktop
D
UL Listed or CSA Approved
E
Conduit Connector
2. Attach the UL listed conduit connector (E), to the junction box (not provided).
3. Thread the cable from the cooktop (D) through the conduit connector to
access the wires, and then tighten the conduit connector screw.
4. Connect the 2 black wires (B) together using a UL listed wire connector.
5. Connect the 2 red wires (C) together using a UL listed wire connector.
6. Connect the 2 ground (green or bare) wires (F) together using a UL listed wire
connector (G).
7. Attach a UL listed wire connector to the neutral (white) wire (H) from the house
electrical supply.
8. Gently tuck the wire connections into the junction box, and install the junction
box cover.

STEP 5 - COMPLETE INSTALLATION

1. Clean cooktop before use with a solution of mild detergent and warm water.
Dry thoroughly with a soft cloth. For more information, see "Cooktop Care" in
the User Manual.
2. Reconnect power at the circuit breaker or fuse box.
3. Turn on each element to check that it is heating correctly.
4. Check that the indicator lights on the control panel, and the interior oven lights
illuminate correctly.
If the cooktop does not operate correctly, check the following:
•
Household fuse is intact and tight; or circuit breaker has not tripped.
•
Cooktop is plugged into a grounded outlet.
•
Electrical supply is connected.
Contact a qualified electrician to verify the electrical supply.
a
b
c
d
11
i
h
g
f
e
Ground (Green or Bare) Wire
F
UL Listed Wire Connector
G
Neutral (White) Wire
H
House Electrical Supply
I