Hitachi Compute Blade 2500 series, Compute Blade 500 series Installation Manual page 40

Note:
1 Add this parameter if LPAR manager version is 59-41/79-41 or later for CB 2000.
.
Add this parameter if LPAR manager version is 01-60 or later for CB 2500/500.
Table 2-4 Setting items and values after OS installation (for Serial console)
/boot/grub/grub.conf
(For EFI boot, /boot/efi/EFI/
redhat/grub.conf)
/etc/sysconfig/init
NIC scheduling
Shared NIC and
virtual NIC
Dedicated NIC
VF NIC
2-20
Hitachi Compute Blade Series OS Installation Guide for Red Hat Enterprise Linux
Item (file)
Item (file)
Table 2-5 NIC device name and type of LAN drivers
mode
®
Intel
1 ®
Intel
Broadcom 1 Gbps Ethernet
®
Intel
Emulex 10 Gbps Ethernet
Emulex 10 Gbps Ethernet
1
Red Hat Enterprise Linux 6
mce=0
pci=noaer
no_timer_check
When using Kdump, change to the following:
crashkernel=[arbitrary value]M@[ arbitrary
value ]M
Value (required)
Comment out the following line in splashimage=(hd0,0)/
grub/splash.xpm.gz:
(Before) splashimage=(hd0,0)/grub/splash.xpm.gz
(After) #splashimage=(hd0,0)/grub/splash.xpm.gz
Add the following two lines between hiddenmenu line and
the title line:
CB 2000 serial --unit=0 --speed=115200
CB 2500/500 serial --unit=1 --speed=115200
terminal --timeout=10 serial console
Add the following at the end of the kernel line:
CB 2000 console=ttyS0,115200
CB 2500/500 console=ttyS1,115200
Change BOOTUP as follows:
(Before) BOOTUP=color
(After) BOOTUP=serial
Device name
1 Gbps Ethernet
1 Gbps Ethernet
10 Gbps Ethernet
Value (required)
LAN driver
igb LAN driver
igb LAN driver
tg3 LAN driver
ixgbe LAN driver
be2net LAN driver
be2net LAN driver