Setting Up After Installation On Lpar - Hitachi Compute Blade 2500 series, Compute Blade 500 series Installation Manual

When using Red Hat Enterprise Linux 6.5, download the kernel security
update from the Red Hat web page referring to the following table, and
then apply the kernel security update.
Model name
CB 520X
CB 520H B3
Red Hat, Inc
https://rhn.redhat.com/
The setting up after installation is completed. Perform
page 3-2.

Setting up after installation on LPAR

This section describes the further settings and driver update required for
running Red Hat Enterprise Linux 6 on the LPAR. If the settings are already
made, setting repetition is not required. If the setting values are different
from those shown in the following table, the guest OS may not work properly.
/etc/inittab
Offload option settings
/etc/sysctl.conf
Kernel line in /boot/grub/grub.conf
(For EFI boot, /boot/efi/EFI/redhat/
grub.conf)
Hitachi Compute Blade Series OS Installation Guide for Red Hat Enterprise Linux
Table 2-2 Updating kernel
Supported OS
Red Hat Enterprise Linux 6.5
Table 2-3 Setting items and values after OS installation
Item (file)
Red Hat Enterprise Linux 6
32bit: X86
2.6.32-431.20.3.el6
Installing Utilities on
Value (required)
Change it to id:3:initdefault:
See Table 2-6 Offload option settings on page
2-23.
Add the following:
kernel.printk=3 4 1 7
kernel.sysrq=1
kernel.unknown_nmi_panic=0
kernel.panic_on_unrecovered_nmi=1
Add the following:
kernel.panic_on_io_nmi=1
Add the following:
nmi_watchdog=0
1
vga=792
Delete the following:
quiet
rhgb
Add the following:
nmi_watchdog=0
Supported kernel
64bit: X86_64
2-19