Connecting The Components - Artel MVS Quick Start Manuals

Connecting the Components

Plate Reader
• Plug one end of the power cord into the power
supply for the Plate Reader and the other end
into the power strip on the top shelf of the Mobile
Workstation cabinet.
• Connect one end of the USB cable into the Plate
Reader and the other end into the MVS USB Hub.
• Insert the remaining plug on the power supply
into the power receptacle on the back of the
Plate Reader and tighten the attached threaded
connector (do not over-tighten).
Plate Shaker
• Connect the BioShake 3000* Plate Shaker
to its power supply using the single-pronged
connector.
• Insert the standard plug of the power supply into
the attached power strip located on the top shelf
of the Mobile Workstation cabinet.
• Connect the standard serial connector to the
Keyspan USB adapter. Connect the USB adapter
to the MVS USB Hub.
*Instructions for other plate shakers may be found in the
Procedure Guide.
Computer
• Plug the three-prong end of the power supply
Data Manager
cord into the power strip on the top shelf of the
Mobile Workstation cabinet.
• Plug the round end of the cord into the side of
the Portable Computer.
• Plug the MVS USB Hub into a USB 3 Port on the
Portable Computer.
Bar Code Reader
• Plug the end of the cord attached to the MVS
Bar Code Reader into the MVS USB Hub.
System
Ensure that the power switch on the power strip is
off before proceeding.
• Plug the power strip located on the middle shelf
of the Mobile Workstation into a three-prong
electrical receptacle near the instrument under
test.
• Check that each individual component is
powered off, and then depress the switch to
energize the power strip.
4