Worx Landroid M WG794E Programming Manual

Programming guide

Control Panel and menu

Sends the Landroid M to its charging base during
®
operation and activates charging
Shortcut key to start mowing.
Input numbers to set time, date
To stop the Landroid M during its operation
®
(Including charging) Release from error alarm.

Menu overview

Programming

After you have successfully installed the Landroid
simply follow the step by step guide below.
Start
To quick start your Landroid M, first press
®
is the shortcut button to command your Landroid
for charging and mow the grass near boundary wire at the same time. During Customize work time and Auto work time, Landroid
charging station automatically without mowing the grass. The Landroid
charging base. Once charging is complete, the Landroid
base.
Setting
OK
Press to enter the submenu. Use the

1. General setting (

HOME
START
NUMBER PAD
STOP
HOMEPAGE
M, it is now ready to be programmed according to your schedule. To program your Landroid
®
until the Landroid
®
® M to start mowing. Press
M will automatically resume mowing or if it has finished mowing it will stay in the charging
®
keys to select General setting, Working time or Security. Then press OK.
)
HOMEPAGE
Displays the state of your setting
POWER ON/OFF
Turns the Landroid
RETURN
Back to proceeding menu
Select up
Select down
OK
Confirms any setting.
Note: Make sure you confirm your selection within
30 secs or the display will return to previous menu.
General Setting
Working Time
Security
M turns on and then press .
to keep working and press
® M will work continuously until it's out of battery and then it will return to the
M on and off
®
Language
Time Format
Date Format
Set Date & Time
Rain Start Delay
Auto Work Time
Customize Work Time
Customize Work Area
Activate PIN Code
Change PIN Code
Alarm Level
M,
®
to make Landroid ® M go back
M will return to the
®
EN