Installation/Connection - Kenwood KDC-BT268U Instruction Manual

REFERENCES
Change the display information
Each time you press DISP, the display information changes.
• If the information is unavailable or not recorded, "NO TEXT", "NO INFO", or other information
(eg. station name, playing time) appears.
Source name
STANDBY Source name Clock
TUNER Frequency Clock (back to the beginning)
(For FM Radio Broadcast Data System stations only)
Station name Radio text
Clock (back to the beginning)
CD or USB (For CD-DA)
Disc name/Artist Track title/Artist
beginning)
(For MP3/WMA/AAC/WAV/FLAC files)
Track title/Artist Album title/artist
time Clock (back to the beginning)
iPod USB/ When [MODE OFF]/[BROWSE MODE] is selected ( 8):
iPod BT or Track title/Artist Album title/Artist
ANDROID the beginning)
PANDORA/ Station name Shared/Radio station
PANDORA BT Playing time Clock
IHEARTRADIO Station name Track title/Artist
BT AUDIO Track title/Artist Album title/Artist
the beginning)
AUX Source name Clock
Display information
(back to the beginning)
Radio text+ Title/Artist Frequency
Playing time Clock (back to the
Folder name File name
Playing time Clock (back to
Track title Artist Album title
(back to the beginning)
Clock (back to the beginning)
Playing time Clock (back to
(back to the beginning)

INSTALLATION/CONNECTION

Warning
• The unit can only be used with a 12 V DC power supply, negative ground.
• Disconnect the battery's negative terminal before wiring and mounting.
• Do not connect Battery wire (yellow) and Ignition wire (red) to the car chassis or Ground wire
(black) to prevent a short circuit.
• Insulate unconnected wires with vinyl tape to prevent a short circuit.
• Be sure to ground this unit to the car's chassis again after installation.
Caution
• For safety's sake, leave wiring and mounting to professionals. Consult the car audio dealer.
• Install this unit in the console of your vehicle. Do not touch the metal parts of this unit during
and shortly after use of the unit. Metal parts such as the heat sink and enclosure become hot.
• Do not connect the [ wires of speakers to the car chassis or Ground wire (black), or connect
them in parallel.
• Mount the unit at an angle of less than 30º.
• If your vehicle wiring harness does not have the ignition terminal, connect Ignition wire (red)
to the terminal on the vehicle's fuse box which provides 12 V DC power supply and is turned
on and off by the ignition key.
Playing
• Keep all cables away from heat dissipate metal parts.
• After the unit is installed, check whether the brake lamps, blinkers, wipers, etc. on the car are
working properly.
• If the fuse blows, first make sure the wires are not touching car's chassis, then replace the old
fuse with one that has the same rating.
Basic procedure
1 Remove the key from the ignition switch, then disconnect the [ terminal of the car
battery.
2 Connect the wires properly.
See Wiring connection. ( 29)
3 Install the unit to your car.
See Installing the unit (in-dash mounting). ( 28)
4 Connect the [ terminal of the car battery.
5 Press to turn on the power.
6 Detach the faceplate and reset the unit. ( 3)
ENGLISH 27