Connecting External Components; Connecting The Fm And Am Antenna - Samsung HT-DT79 Instruction Manual

Connecting External Components

Connecting an External Analog Component
Example: Analog signal components such as a VCR.
Audio Cable
(not supplied)
If the external analog compo-
nent has only one Audio Out,
connect either left or right.
1
Connect AUX (Audio) In on the Home Theater to Audio Out on the external analog compo-
nent.
•
Be sure to match connector colors.
2
Press AUX button on the remote control to select 'AUX1', 'AUX2' or 'USB'.
•
You can also use the FUNCTION button on the main unit.
➝ TAPE ➝ AUX1 ➝ AUX2 ➝ USB ➝ FM ➝ AM
The mode switches as follows: DVD/CD
•
You can connect the Video Output jack on your VCR to the TV, and connect the Audio
Note
Output jacks on the VCR to this product.
15
Connecting the FM and AM Antennas
FM Antenna (supplied)
FM antenna connection
1. Connect the FM antenna supplied to the
FM 75Ω COAXIAL terminal.
2. Slowly move the antenna wire around until
you find a location where reception is good,
then fasten it to a wall or other rigid surface.
Cooling Fan The cooling fan supplies cool air to the unit to prevent overheating.
Please observe the following cautions for your safety.
•
Make sure the unit is well-ventilated. If the unit has poor ventilation, the temperature inside the unit could rise
and may damage it.
• Do not obstruct the cooling fan or ventilation holes. (If the cooling fan or ventilation holes are covered with a
newspaper or cloth, heat may build up inside the unit and fire may result.)
•
This unit does not receive AM broadcasts.
Note
AM Loop Antenna
(supplied)
Snap the tabs on the
loop into the slots of the
base to assemble the
AM loop antenna.
AM antenna connection
1. Connect the AM loop antenna supplied
to the AM and terminals.
•
Insert the black wire into the black terminal and the
white wire into the white terminal.
2. If reception is poor, connect an outdoor
single vinyl-covered wire to the AM
terminal. (Keep the AM loop antenna
connected).
16
GB