Flyzone DHC-2T Turbo Beaver Instruction Manual page 16

❑
6. Repeat the same procedure for the rudder, making
sure it is centered. Lock the pushrod in place on the servo
arm with the screw and threadlocker.
❑
7. Move the dial or switch on your transmitter that
controls the fl aps to the "up" position, rotating the fl ap
servo arm clockwise. Remove the screw in the fl ap servo
arm, wet the threads with threadlocker, and then reinstall
and tighten the screw so the fl aps will be in their fully
retracted ("up") position.
❑
4. With the system still on, make sure the ailerons are
centered and aligned with the wing tips. If necessary, apply a
few clicks of aileron trim to get the ailerons centered. If more
than a few clicks of trim are required, or if you cannot get
both ailerons neutralized, a small screwdriver may be used
to pop off one or both aileron servo covers to access the
pushrods. Adjust the pushrods in the connectors to get the
ailerons centered. When fi nished, replace the cover, press
into position, and hold in place with tape or a dab of glue.
❑
5. Test fi t the battery hatch onto the fuselage.
16