Sleep Functions; Troubleshooting - Samsung HT-DL200 Instruction Manual

Sleep Function
B
To set up Sleep
Press the Sleep button.
•
Each time the button is pressed the selection
toggles as follows: SLEEP 10
SLEEP 30 SLEEP 60 SLEEP 90
SLEEP 120 SLEEP 150
To Review Sleep Setting
•
The remaining time for the selected Sleep time is
displayed.
•
Pressing the button once again changes the Sleep
time from the last setting.
39
Sleep
What is the
Sleep function?
SLEEP 20
You can set the delay time so that
the unit powers off automatically
after a preset period of time.
OFF.

Troubleshooting

Problem
•
Is the disc installed with the label side facing up?
The disc tray does not
•
Is the power cord plugged securely into the power outlet?
open.
•
Turn off the power to the unit by pressing the Power (
button and turn it back on.
•
Check the region number of the DVD.
•
Disc does not play. DVD discs purchased abroad may not be playable.
•
This player cannot play CD-ROMs, DVD-ROMs, etc.
•
Check the rating level of the DVD.
Playback does not start
•
Check whether the disc has any scratch marks or is deformed?
immediately when the
Play/Pause button is pressed.
•
No sound is heard during high-speed playback, slow playback,
and step motion playback modes.
•
Are the speakers properly connected? Is the speaker Setup
No sound is produced.
correctly customized?
•
Is the disc severely damaged?
The disc may be dirty. Wipe off fingerprints or dirt.
Sound can be heard only
•
When listening to a CD or radio, sound is output to the front
from a few speakers and speakers only (L/R). Select the "PRO LOGIC" option by pressing
the Pro Logic button on the remote control unit to use all six
not all six.
speakers.
•
Check whether your DVD disc is 5.1 CH compatible.
•
Was the player moved suddenly from a cold pace to a warm one?
Picture does not appear; sound
When condensation forms inside the player, remove the disc
is not produced; the disc tray
and let the player stand for 1 or 2 hours with the power on. (You
opens 2-5 seconds later.
can use the player after the condensation disappears.)
Sound quality is irregu- •
Are the speaker cables loose?
lar.
•
Is there any dirt or debris at the end of the speaker connector?
Dolby Digital 5.1 Channel
•
Does the disc being played show the "Dolby Digital 5.1CH" mark ?
Surround Sound is not
5.1-channel sound is reproduced only if the disc is recorded with
5.1 channel sound.
being reproduced.
•
Is the DVD player connected to the proper speakers?
Check
GB
)
40