Setting The Speaker Mode; Setting The Test Tone - Samsung HT-DB390 Instruction Manual

Setting the Speaker Mode

Signal outputs and frequency responses from the speakers will automatically be adjusted
according to your speaker configuration and whether certain speakers are used or not.
Press Cursor
In Stop mode,
1 2
button to move to
press MENU
'Audio' and then
button.
press ENTER button.
Press Cursor
In the Speaker , buttons to move
3 4
to the desired
Setup, press the
speaker and then
ENTER button again.
press ENTER button.
•
For C, LS, and RS, each time the button
is pressed, the mode switches
alternately as follows: SMALL
•
For L and R, the mode is set to SMALL.
SMALL : Select this when using the speakers.
NONE : Select this when no speakers are installed.
Note
•
Depending on PRO LOGIC and STEREO, the speaker mode may vary.
47
, ,
NONE.

Setting the Test Tone

Use the Test Tone feature to check the speaker connections and to adjust the speaker levels.
In Stop mode,
1 2
press MENU
button.
Press RETURN button to return to the previous level.
Press MENU button to exit the setup screen.
Alternate method: press the TEST TONE button on the remote.
Press TEST TONE button.
•
Test tone will be produced as follows:
When playing a DVD or CD, this will work
only in Stop mode.
•
Use this function to check that each speaker is
correctly connected and that there is no problem.
To end the test tone,
press TEST TONE button again.
Press Cursor Press Cursor
3
button to move to to move to 'TEST
'Audio' and then TONE' and then press
press ENTER button. ENTER button.
•
The test tone will be sent to L
R RS LS
If the ENTER button is pressed again
at this time, the test tone will stop.
L: Front Speaker (L) C: Center Speaker
R: Front Speaker (R) LS: Rear Speaker (L)
Multi-Channel Pro Logic Mode
Start
button
C
SW in that order.
SW: Subwoofer
RS: Rear Speaker (R)
48