Wireless Network
You can connect to the network with a Wireless IP sharer.
1.
Connect the included wireless LAN adapter to the Wireless LAN jack on the back panel of the
product.
- This unit is compatible with the supplied Wireless LAN Adapter.
- You can also use the wireless network by connecting the Wireless LAN Gender Adapter to the
Wireless LAN Adapter, and then attaching the Wireless LAN Adapter to the Gender Adapter.
2.
Set the network options. (See page 40)
Broadband
service
Wireless IP sharer
PC
Networking with PC for
AllShare function
(See pages 62~63)
✎
NOTE
You must use a wireless IP sharer that supports IEEE 802.11 a/b/g/n. (n is recommended for stable operation of the
wireless network.)
Wireless LAN, by its nature, may cause interference, depending on the use condition (AP performance, distance, obstacles,
interference by other radio devices, etc).
Set the wireless IP sharer to Infrastructure mode. Ad-hoc mode is not supported.
When applying the security key for the AP (wireless IP sharer), only the following is supported.
1)
Authentication Mode : WEP, WPAPSK, WPA2PSK
2)
Encryption Type : WEP, AES
For the AllShare function, a PC must be connected in the network as shown in the fi gure.
iPod
Connecting the FM Antenna
FM Antenna (supplied)
iPod
OR
Wireless LAN Adapter
1.
Connect the FM antenna supplied to the FM
Antenna Jack.
2.
Slowly move the antenna wire around until
you fi nd a location where reception is good,
then fasten it to a wall or other rigid surface.
✎
NOTE
This product does not receive AM broadcasts.
iPod
29
English