Samsung AH68-02262R User Manual page 21

5. Insert and tighten three large screws (5x15, For connecting
Stand Pole & Stand Base) into the three holes on the bottom
side of the stand-base as shown in the illustration.
!
CAUTION

When you use a torque screwdriver, be careful not to put
excessive force. Otherwise, it runs idle or can be damaged.
(torque screwdriver- below 15 kg.f.cm)
6. Connect the speaker wire to the speaker jack.
7. Fully insert the Stand Bracket into the speaker's clasp to stand
speaker.
8. Insert and tighten two small screws (4x20, For connecting Stand
Bracket & Speaker) into the two holes to connect them.
9. This is the appearance after the speaker is installed.
Follow this steps to install other speaker.
5
6
7
8
9
21
English