Icom IP100H Instructions page 3

1)
FCC caution: (SAR value is under process)
RF Exposure Information (SAR)
This device meets the government's requirements for exposure to radio waves. This
device is designed and manufactured not to exceed the emission limits for exposure
to radio frequency (RF) energy set by the Federal Communications Commission of
the U.S. Government.
The exposure standard employs a unit of measurement known as the Specific
Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6 W/kg. Tests for SAR are
conducted using standard operating positions accepted by the FCC with the EUT
transmitting at the specified power level in different channels.
The highest SAR value for the device as reported to the FCC is 1.313 W/kg when
placed next to the body.
This radio transmitter
antenna types listed below with the maximum permissible gain and required
antenna impedance for each antenna type indicated. Antenna types not included in
this list, having a gain greater than the maximum gain indicated for that type, are
strictly prohibited for use with this device.
Antenna List
No. Manufacturer
1
Exceltek
2
TAIYO YUDEN AH 104N2450D1
Note: The antenna connector is Reverse SMA type.
Canadian caution should be included French version, as below:
Canada, avis d'Industry Canada (IC)
Cet appareil numérique de classe B est conforme aux normes canadiennes ICES‐003 et
RSS‐210.
Son fonctionnement est soumis aux deux conditions suivantes : (1) cet appareil ne
doit pas causer d'interférence et (2) cet appareil doit accepter toute interférence,
notamment les interférences qui peuvent affecter son fonctionnement.
has been approved by FCC to operate with the
FCCID: AFJ357600
Part No. Antenna
Type
N/A Dipole
Monopole
Peak Gain
2.0 dBi for 2.4GHz
2.0 dBi for 5.15~5.25GHz
2.1 dBi for 2.4GHz
2.4 dBi for 5.15~5.25GHz
Remark
External Antenna
Internal Antenna