Configure The Rfid Module Settings - Intermec IP2L User Manual

Chapter 2 — Create and Use RFID Applications

Configure the RFID Module Settings

DRAFT
16
Configure the RFID Module settings to control how the reader
operates and reads tags.
1 Go to Intermec Settings.
2 Tap the RFID > Application Connection.
3 Configure the RFID Module settings.
4 Tap OK. Your settings are saved.
RFID Module Settings Descriptions
Setting
Tag Type
Dense Reader Mode
LBT Channel
LBT Scan Enable
Field Separator
Description
Select the tag types you the RFID reader to read.
This setting is equivalent to the TAGTYPE BRI
attribute.
Allows the reader to hop between channels within
a certain frequency sectrum to prevent other
readers in the area form interfering with one
another.
This setting is equivalent to the
DENSEREADERMODE or DRM BRI attribute.
Sets the default transmit channel of the available
ETSI 302-208 channels. When you enable LBT
scanning, the channel scan sequence starts with
this LBT channel. When you disable LBT scanning
(as in the 4 channel mode) the LBT channel is the
only channel used. The range for 10 chanel mode
is 4 to 13.
When LBT scanning is enabled, the algorithm
scans the available ETSI 302-208 channels for a
free transmit channel.
This setting is equivalent to the
LBTSCANENABLE BRI attribute.
Sets the space character to be used for separating
fields in tag data. Choose from space ( ), comma
(,), colon (:), semicolon (;), tab, caret (^), or tilde
(~). Default is space.
This setting is equivalent to the FIELDSEP BRI
attribute.
IP2L Snap-On LF/UHF RFID Reader User Guide