Danfoss EvaKool Travelmate Instruction Manual page 3

Using the Fridge
NOTE: IF THE UNIT IS POWERED OFF ONLY AN ORANGE LED WILL BE
•
ILLUMINATED. TO TURN ON YOUR UNIT PLEASE HOLD THE ON/OFF
SWITCH DOWN UNTIL THE RUN LIGHT CHANGES TO GREEN AND THE LED
DISPLAY IS ILLUMINATED.
Temperature setting range
•
Plug in the DC or AC power cable. Use the ON/OFF switch to run the fridge. The LED
•
display on the control panel will light up and the interior temperature will be displayed.
Press SET and then press the
•
△
button to increase while the button
temperature press set three times or leave for 5 seconds. The display board will display the
current temperature inside the unit after the target temperature is set. After approximately 5
minutes the displayed temperature will start to decrease.
If the power supply is cut off, the refrigerator will switch off automatically and then
•
automatically switch on again when the unit receives power.
To change the fridge between ºC and ºF. Press SET twice and then
•
change the setting.
To change the battery voltage setting press the SET button three times and the use the
•
▽
and DOWN buttons to change between the settings. Leave the unit for 5 seconds to set this
setting. The three voltage settings are as follows :- (We advise to keep the setting on LOW)
o LOW – 10.4 Volts
o MED – 11.2 Volts
o HIGH – 12 Volts
3 | P a g e
Instruction Manual
： ～ ～
- 20ºC 2 0ºC, -4ºF
△ ▽
UP and DOWN buttons to adjust the temperature. Press the
▽
to decrease the temperature. To lock in the target
；
6 8ºF
△
UP or
▽
DOWN to
△
UP