Safety Instructions; Notes On Using The Product; Operation - Danfoss EvaKool Travelmate Instruction Manual

Features:
Reliable cooling system – Danfoss compressor
•
Efficient electronic technology, low energy consumption
•
Multi-voltage system (DC 12-24 Volt) and (AC 100-120/220-240 Volt)
•
Digital Battery Protection, protect your vehicle battery effectively
•
1.

Safety Instructions

Warning: Do not touch exposed cables.
•
Warning: Do not use fridge if you suspect any connections could be wet.
•
When using the fridge in the vehicle or boat, please make sure the circuit being used is fused.
•
Any installation of DC power sources should be handled by a qualified professional.
•
Make sure the source voltage is correct. The technical data label has the voltage data.
•
Do not place any electrical devices inside the refrigerator as moisture could harm these
•
devices.
2.

Notes on using the product

Your refrigerator requires good ventilation, especially around the vents of the refrigerator;
allow a gap of at least 200mm around the vents and 100mm around the rest of the unit.
Avoid humidity: Humidity inside the appliance can form frost and impair cooling.
Do not allow frost to build up. Never clean the appliance using a hose and never submerge the
unit in any liquid.
Avoid placing your refrigerator near a heat source. This helps the refrigerator to work more
efficiently and keep the contents cool.
Place the refrigerator on a flat surface and away from any edges. When using the fridge in a
vehicle, please use a fastening device to secure it.

3. Operation

Power ： ： ： ： The electronic control module controls the compressor motor and has the function of
a three stage battery protection. When the input voltage drops below the minimum, the
compressor will cut out; when the voltage comes back up to the cut-in value, the compressor
will restart automatically.
Battery Protection: The Danfoss compressor requires over 10.4 Volts (12 Volt System) or
23.0 Volts (24V System) to operate. If the voltage drops below this the fridge will stop
running.
Cable Specification
The DC cables must have a suitable cross-section for their length, according to this table:
*Note: The length is from the battery to the refrigerator.
Cable Area
[mm2]
2.5
4
6
10
2 | P a g e
Instruction Manual
12V Max Cable
Length*
AWG [m]
12 2.5
12 4
10 6
8 10
24V Max Cable
Length*
[ft.] [m]
8 5
13 8
20 12
33 20
[ft.]
16
26
39
66