Section 1 Warning - Omega DRST-AC User Manual

1
Warning
This device is designed for connection to hazardous electric voltages. Ignoring this
warning can result in severe personal injury or mechanical damage.
To avoid the risk of electric shock and fire, the safety instructions of this guide must be
observed and the guidelines followed. The specifications must not be exceeded, and
the device must only be applied as described in the following.
Prior to the commissioning of the device, this installation guide must be examined
GENERAL
carefully.
Only qualified personnel (technicians) should install this device. If the equipment is
used in a manner not specified by the manufacturer, the protection provided by the
equipment may be impaired.
Until the device is fixed, do not connect hazardous voltages to the device. The
following operations should only be carried out on a disconnected device and under
ESD safe conditions:
HAZARD OUS
VOLTAGE
Repair of the device and replacement of circuit breakers must be done by
Omega A/S only.
Do not open the front plate of the device as this will cause damage to the connector for the
display / programming front DRSL-DISPLAY.
This device contains no DIP-switches or jumpers.
DRST Series must be mounted on a DIN rail according to DIN EN 60715.
CAUTION
Section 1.2 - Symbol Identification
Triangle with an exclamation mark: Read the manual before installation
and commissioning of the device in order to avoid incidents that could lead
to personal injury or mechanical damage.
The CE mark proves the compliance of the device with the essential
requirements of the directives.
The double insulation symbol shows that the device is protected by double
or reinforced insulation.
General mounting, connection and disconnection of wires.
Troubleshooting the device.
WARNING
WARNING
WARNING
5